Smc-networks SMC TigerAccess SMC7824M/FSW Instrukcja Użytkownika Pobierz pdf (Strona 52)

100

101

ASIC

ONFIGURATION

2-6

4. Type “username admin password 0 password,” for the Privileged Exec

level, where password is your new password. Press <Enter>.

Setting an IP Address

You must establish IP address information for the switch to obtain

management access through the network. This can be done in either of the

following ways:

Manual — You have to input the information, including IP address and

subnet mask. If your management station is not in the same IP subnet as

the switch, you will also need to specify the default gateway router.

Dynamic — The switch sends IP configuration requests to BOOTP or

DHCP address allocation servers on the network.

Manual Configuration

You can manually assign an IP address to the switch. You may also need to

specify a default gateway that resides between this device and management

stations that exist on another network segment. Valid IP addresses consist

of four decimal numbers, 0 to 255, separated by periods. Anything outside

this format will not be accepted by the CLI program.

Note: An IP address for this switch is obtained via DHCP by default.

Username: admin

Password:

CLI session with the TigerAccess 10/100 is opened.

To end the CLI session, enter [Exit].

Console#configure 18-3

Console(config)#username guest password 0 [password] 21-2

Console(config)#username admin password 0 [password]

Console(config)#

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 747 748

Komentarze do niniejszej Instrukcji

Brak uwag

Smc-networks SMC TigerAccess SMC7824M/FSW Instrukcja Użytkownika Strona 52

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Smc-networks SMC TigerAccess SMC7824M/FSW