SMC Networks SMC8606T Instrukcja Użytkownika Pobierz pdf (Strona 16)

WITCH

ANAGEMENT

1-4

In-Band Connections

Prior to accessing the switch via a network connection, you must

first configure it with a valid IP address, subnet mask, and default

gateway using an out-of-band connection or the BOOTP protocol.

After configuring the switch’s IP parameters, you can access the

on-board configuration program from anywhere within the

attached network. The on-board configuration program can be

accessed using Telnet from any computer attached to the network.

The switch can also be managed by any computer using a Web

browser (Internet Explorer 4.0, or Netscape Navigator 4.0 or

above), or from a network computer using network management

software such as EliteView.

Notes: 1. By default BOOTP is disabled. To enable BOOTP, see

“IP Configuration” on page 2-13.

2. Use the Network Configuration menu to specify the

maximum number of simultaneous Telnet sessions that

are supported by the system (up to four).

3. The on-board program only provides access to basic

configuration functions. To access the full range of

SNMP management functions, you must use SNMP-

based network management software, such as SMC’s

free EliteView software.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 181 182

Brak uwag

SMC Networks SMC8606T Instrukcja Użytkownika Strona 16