SMC Networks SMC6724L3 INT Instrukcja Użytkownika Pobierz pdf (Strona 44)

NSTALLING

THE

WITCH

3-6

Installing an Optional Module into the Switch

Figure 3-4. Installing an Optional Module

Caution: DO NOT install slide-in modules with the switch powered on.

Be sure you power off the switch before installing any module.

To install an optional module into the switch, do the following:

1. Disconnect power to the switch.

2. Remove the blank metal plate (or a previously installed module) from

the appropriate slot by removing the two screws with a flat-head

screwdriver.

3. Before opening the package that contains the module, touch the bag to

the switch casing to discharge any potential static electricity. Also, it is

recommended to use an ESD wrist strap during installation.

4. Remove the module from the anti-static shielded bag.

5. Holding the module level, guide it into the carrier rails on each side

and gently push it all the way into the slot, ensuring that it firmly

engages with the connector.

100BASE-FX Singlemode Module

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 81 82

Brak uwag

SMC Networks SMC6724L3 INT Instrukcja Użytkownika Strona 44