SMC Networks SMC8024L2 Instrukcja Użytkownika Pobierz pdf (Strona 40)

NSTALLING

THE

WITCH

3-8

Note: SFP transceivers are hot-swappable. The switch does not need to

be powered off before installing or removing a transceiver.

However, always first disconnect the network cable before

removing a transceiver.

Note: SFP transceivers are not provided in the switch package.

Connecting to a Power Source

To connect a device to a power source:

1. Insert the power cable plug directly into the socket located at the back

of the device.

Figure 3-6 Power Socket

2. Plug the other end of the cable into a grounded, 3-pin, AC power

source.

Note: For international use, you may need to change the AC line

cord. You must use a line cord set that has been approved for

the socket type in your country.

3. Check the front-panel LEDs as the device is powered on to be sure

the Power LED is on. If not, check that the power cable is correctly

plugged in.

100-240V ~50-60Hz 0.8A

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 79 80

Brak uwag

SMC Networks SMC8024L2 Instrukcja Użytkownika Strona 40