Smc-networks TigerStack 100 1000BASE-X Instrukcja Użytkownika Pobierz pdf (Strona 105)

IP C

ONFIGURATION

3-11

IP Configuration

Use the IP Configuration screen to set the bootup option, configure the IP

address for the on-board management agent, or set the number or

concurrent Telnet sessions allowed. The screen shown below is described

in the following table.

Parameter Default Description

IP State USER-CONFIG Specifies whether IP functionality is enabled via

manual configuration, or set by Boot Protocol

(BOOTP). Options include:

USER-CONFIG - IP functionality is enabled

based on the default or user specified IP

Configuration. (This is the default setting.)

BOOTP Get IP - IP is enabled but will not

function until a BOOTP reply has been received.

BOOTP requests will be periodically broadcast

by the switch in an effort to learn its IP address.

(BOOTP values can include the IP address,

default gateway, and subnet mask.)

IP Address 10.1.0.1 IP address of the switch you are managing. The

switch supports SNMP over UDP/IP transport

protocol. In this environment, all systems on the

Internet, such as network interconnection

devices and any PC accessing the on-board agent

(or running EliteView) are assigned an IP

address. Valid IP addresses consist of four

decimal numbers, of 0 to 255, separated by

periods. Anything outside of this format will not

be accepted by the configuration program.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 177 178

Brak uwag

Smc-networks TigerStack 100 1000BASE-X Instrukcja Użytkownika Strona 105